{"id":234,"date":"2011-09-16T04:26:58","date_gmt":"2011-09-16T04:26:58","guid":{"rendered":"http:\/\/www.patternliteracy.com\/?page_id=234"},"modified":"2015-07-12T22:04:55","modified_gmt":"2015-07-12T22:04:55","slug":"how-to-the-ultimate-bomb-proof-sheet-mulch","status":"publish","type":"page","link":"https:\/\/tobyhemenway.com\/resources\/how-to-the-ultimate-bomb-proof-sheet-mulch\/","title":{"rendered":"How To: The Ultimate, Bomb-Proof Sheet Mulch"},"content":{"rendered":"
\"Bomb-Proof<\/a>
Bomb-Proof Sheet Mulch – Click for larger image<\/figcaption><\/figure>\n

Sheet mulch can be as simple as a layer of newspapers topped by 8 to 12 inches of nearly any mulch material. But if you want to build the perfect sheet mulch, here\u2019s how:<\/p>\n

If this is your \ufb01rst sheet mulch, start small. Sheet mulch gobbles up a tremendous amount of organic matter\u2014the roughly 2 cubic yards held by a full-sized pickup truck will cover about 50 square feet. But don\u2019t scrimp. It\u2019s much better to blanket a small area thoroughly than to spread the mulch too thin to smother weeds or feed the soil properly. Choose a site that\u2019s not more than 200 square feet, in the proper location for the intended plants, and preferably near the house. Remember your zones: Deeply mulched beds will soon be covered with a riot of plant life, and you want these awesomely productive areas right outside your door, to easily tend or to admire the many avian and insect visitors.<\/p>\n

Here\u2019s a materials list for the perfect sheet mulch:<\/p>\n

    \n
  1. A 2- to 3-foot stack of newspaper, minus any glossy sections, whose inks may contain metal pigments (the black and colored inks on standard newsprint are soy-based and nontoxic), or about 300 square feet of corrugated box cardboard without staples or plastic tape. You can also use cloth, old clothing, or wool carpet, provided they contain no synthetic fabric, but these take far longer to decay than paper.<\/li>\n
  2. Soil amendments, depending on your soil\u2019s needs: lime, rock phosphate, bonemeal, rock dust, kelp meal,\u00a0 blood meal, and so on.<\/li>\n
  3. Bulk organic matter: straw, spoiled hay, yard waste, leaves, seaweed, \ufb01nely ground bark, stable sweepings, wood shavings, or any mixture of these, ideally resulting in an overall C:N ratio of 100\/1 to 30\/1. Grass clippings are also good, but only when mixed with other, \u201cbrown\u201c mulches, otherwise their high nitrogen content causes anaerobic\u2014and smelly, slimy\u2014decomposition. You will need about 4 to 8 cubic yards of loosely piled mulch for 100-200 square feet, or 6 to 10 two-string bales of hay or straw.<\/li>\n
  4. Compost, about 1\u20444 to 1\u20442 cubic yard (6 to 12 cubic feet).<\/li>\n
  5. Manure: 1\u20444 to 1 cubic yard, depending on the concentration and amount of bedding mixed in. About 6 cubic feet of composted steer manure or other bagged product will be plenty.<\/li>\n
  6. A top layer of seed-free material, such as straw, leaves, wood shavings, bark, sawdust, pine needles, grain hulls, nut husks, or seagrass. You will need roughly 1 cubic yard or 2 to 4 two-string bales.<\/li>\n<\/ol>\n

    If you can\u2019t \ufb01nd every item, don\u2019t worry. Sheet mulching is very forgiving. As long as you have enough newspaper or cardboard, plus organic matter of almost any kind, you\u2019ll end up with great soil. Store your supplies near the chosen site so you won\u2019t have to move them too far on sheet-mulch day. Keep them dry, too.<\/p>\n

    The day before you mulch, water the site well unless the ground is moist from rain. The organisms that will be turning your mulch into rich earth can\u2019t work without water, and once the mulch is in place, it takes a lot of water to moisten the bottom layers. Conversely, it takes a long time for the layers to dry out\u2014you\u2019ve got lots of water storage.<\/p>\n

    After the water has soaked in overnight, slash down any vegetation. Don\u2019t pull up weeds\u2014leave all the native organic matter right there, including the roots. Just clip, mow, scythe, or weed-whack everything down in place. It\u2019s great worm food, and the nitrogen-rich greens and roots will be a tasty starter for the decomposers. Remove any stumps or big woody pieces.<\/p>\n

    Next, add any soil amendments. If your soil is acid, sprinkle on some lime. For alkaline soil, a little gypsum or sulfur will help. A dusting of rock phosphate or bonemeal will supply phosphorus. Greensand, kelp meal, or rock dust will add trace minerals. Use a soil test or your own understanding of your soil\u2019s fertility to guide the type and quantity of soil amendments.<\/p>\n

    If your native earth is clayey or compacted, now is a good time to open it up a bit. Just push a spading fork into the ground, rock it a little, and pull it out. Do this across the entire mulch site. Don\u2019t turn the earth, just poke some holes into it and crack it open to allow better moisture and root penetration and soil-critter movement.<\/p>\n

    Then add a thin layer of high-nitrogen material. This can be manure, blood or cottonseed meal, fresh grass clippings or other lush greens, or cast-off produce from restaurants or markets. For concentrated matter such as rabbit manure or blood meal, sprinkle down enough material to just cover the soil. Grass clippings or bedding-rich manure should go down about an inch thick. While this layer isn\u2019t essential, it attracts worms and burrowing beetles, which will aerate and loosen the soil.<\/p>\n

    Now the fun begins: putting the sheet in sheet mulch. Lay down newspapers and\/or cardboard to create a continuous light-blocking layer that will smother existing plants. Cardboard is very satisfying to use, since those big sheets, especially boxes from appliances and bicycles, cover the ground fast. Overlap the sheets by 6 inches or so to keep weeds from sneaking between them. Newspaper should be laid down 1\/8 to 1\/2 inch thick.<\/p>\n

    As you spread out the sheets, wet them thoroughly. Do this frequently if a breeze comes up\u2014watching your sheet mulch flap away is pretty demoralizing. Soak the sheets several times to make sure the water seeps through. If you\u2019re sheet mulching with a group, this is when hose-fights usually erupt, tugging any well-orchestrated work-party toward mayhem.<\/p>\n

    Try not to walk on the paper, especially after it\u2019s wet, as this pulls the sheets apart and creates gaps. Pretend you\u2019re painting a floor: Start at the far side and work toward the access or materials pile so you won\u2019t walk on your work.<\/p>\n

    Next, toss down another thin layer of nitrogen-rich manure, meal, or fresh green clippings. This will entice the worms up through the soon-to-be rotting sheets, and coax plant-roots downward.<\/p>\n

    On top of this, pour on the bulk mulch, about 8 to 12 inches of loose straw, hay, or other substances listed above. Weed seeds in this layer aren\u2019t a big concern, as a thick, seed-free stratum lies atop this one. Weed seeds seem to rot rather than germinate in the slowly composting mass.<\/p>\n

    Bales of hay or straw don\u2019t have to be fluffed up to their original grassy bulk. Just break the bales into thin \u201cflakes\u201d about 1 to 2 inches thick, and lay down about three thicknesses of these. Broken into several layers and moistened, the dense flakes will expands and compost perfectly well.<\/p>\n

    To create an easily compostable sheet mulch, pay attention to the carbon\/nitrogen ratio in the bulk mulch layer. If you\u2019re using high-carbon materials such as straw or, especially, wood shavings, sprinkle on nitrogen in the form of blood meal or other nitrogen-rich source, or \u201cdilute\u201d the carbonaceous mulch with perhaps one part clover hay, seaweed, grass clippings, or other high-nitrogen mulch for every four of high-carbon matter (see table 4-1 for a list of mulch materials and their C:N ratios). A mulch that is extremely low in nitrogen, such as wood shavings, will be slow to rot down, and may cause anemic plant growth. You don\u2019t have need a perfect C:N balance, just make such there\u2019s some nitrogen in the mix to feed the compost critters.<\/p>\n

    As you build this layer, spray on water every few inches. This layer should be damp but not wet; you\u2019re looking for that wrung-out sponge state. This can take a surprisingly large volume of water. It may take a couple of minutes of soaking every few inches to achieve the damp-but-not-wet state.<\/p>\n

    Atop the bulk mulch, add an inch or two of compost. If this is in short supply, add compost plus whatever soil is on hand to reach the final thickness. Or, if the pile will have a few months to compost before planting, you can substitute manure or several inches of easily compostable material for this layer. But if you plan to plant the sheet mulch within a few weeks, a layer of compost will be necessary to act as a seed bed.<\/p>\n

    The final layer is 2 inches of weed- and seed-free organic matter, such as straw, fine bark, wood shavings, or any of the others listed above. Besides smothering weeds, this layer gives the project, in landscaper jargon, \u201cthat finished look,\u201d which will endear you to your more fastidious neighbors. For planting seeds and starts, push this layer aside to reach the compost\/soil layer right below, just as you would with any mulch.<\/p>\n

    More Excerpts from Gaia\u2019s Garden:<\/strong><\/p>\n